「$bottomcontactnum」：修訂間差異
跳至導覽
跳至搜尋
Jameshuang（留言 | 貢獻） 無編輯摘要 |
無編輯摘要 |
||
| 第4行： | 第4行： | ||
$bottomcontactnum | $bottomcontactnum | ||
1 | 1 | ||
<br>'''<big><big>The $bottomcontactnum setting in GUI interface is here</big></big>''' <br> | |||
1. After setting up the general structure, press '''Set Linear Contact'''.<br> | |||
[[檔案:2D_bottomcontactnum_fig1.jpg|1200px]]<br><br> | |||
2. Press '''Add new epitaxial ranges''' and set up the contact ranges, setting the Contact side to '''Bottom'''.<br> | |||
[[檔案:2D_bottomcontactnum_fig2.jpg|1200px]]<br><br> | |||
3. As you can see, there is a new contact under the structure!<br> | |||
[[檔案:2D_bottomcontactnum_fig3.jpg|1200px]]<br><br> | |||
於 2024年10月26日 (六) 16:57 的最新修訂
$bottomcontactnum can determine that is there a contact at the bottom?
Example
$bottomcontactnum 1
The $bottomcontactnum setting in GUI interface is here
1. After setting up the general structure, press Set Linear Contact.
2. Press Add new epitaxial ranges and set up the contact ranges, setting the Contact side to Bottom.
3. As you can see, there is a new contact under the structure!
