「$RCWAxdiv」：修訂間差異
跳至導覽
跳至搜尋
無編輯摘要 |
無編輯摘要 |
||
| 第13行： | 第13行： | ||
<br>'''<big><big>The $RCWAxdiv setting in GUI interface is here</big></big>''' <br> | <br>'''<big><big>The $RCWAxdiv setting in GUI interface is here</big></big>''' <br> | ||
1. Press '''Add new layers for RCWA''' and fill in the fields as needed!<br> | 1. Press '''Add new layers for RCWA''' and fill in the fields as needed!<br> | ||
[[檔案:2D_RCWAxdiv_fig1.jpg|1200px]] | [[檔案:2D_RCWAxdiv_fig1.jpg|1200px]]<br> | ||
2. The order is from bottom to top.<br> | |||
[[檔案:2D_RCWAxdiv_fig2.jpg|1200px]] | [[檔案:2D_RCWAxdiv_fig2.jpg|1200px]] | ||
於 2024年11月19日 (二) 18:45 的最新修訂
The $RCWAxdiv command is used to set material boundary number in each layer. It also needs to goes with the $RCWAxnode and $RCWAperiod to define position of boundary point and the period of simulation domain. The left boundary point does not need to assign.
$RCWAxdiv
3 3 5 3 3 ... total layer
The $RCWAxdiv setting in GUI interface is here
1. Press Add new layers for RCWA and fill in the fields as needed!
2. The order is from bottom to top.
