$ifelectrode
出自 DDCC TCAD TOOL Manual
於 2018年7月17日 (二) 16:49 由 Yrwu (對話 | 貢獻) 所做的修訂 (已建立頁面，內容為 "$ifelectrode is the command to setup the bias operation range. In the program, there are 4 types of electrical contacts, which are gate, drain, source, and base cont...")
$ifelectrode is the command to setup the bias operation range. In the program, there are 4 types of electrical contacts, which are gate, drain, source, and base contact. The command is as following
$ifelectrode vgstart, vgend, vgstep vdstart, vdend, vdstep vsstart, vsend, vsstep vbstart, vbend, vbstep
