$traceraypath
出自 DDCC TCAD TOOL Manual
於 2019年4月2日 (二) 09:38 由 Yrwu (對話 | 貢獻) 所做的修訂 (已建立頁面，內容為 "$traceraypath is the command to output the ray's path. Because recording the ray path could wast a huge space if many photons are ran. Therefore, the software will o...")
$traceraypath is the command to output the ray's path. Because recording the ray path could wast a huge space if many photons are ran. Therefore, the software will only output certain photons.
The command is
$traceraypath N_photons
N_photons means the program save the ray path every N_photons.
For example:
$traceraypath 100
