$usemubydopeT

$usemubydopeT is to enable the temperature and carrier density dependent mobility module with the predefined function. The function is designed for each region. So if total n regions is used, then you will need to setup n regions. The format is

$usemubydopeT
Type_R1  p1 p2 p3 p4 p5.....p12
Type_R2  p1 p2 p3 p4 p5.....p12
Type_R3  p1 p2 p3 p4 p5.....p12
...
...
... 
Type_RN  p1 p2 p3 p4 .....p12

Type

0: Use the original mobility defined in parameter setions
1: $\mu_{n} = p1 \times \left(\frac{T}{p3}\right) ^{p2}$ , and $\mu_{p} = p4 \times \left(\frac{T}{p6}\right) ^{p5}$
2: $\mu_{n} = p1 +  \left(\frac{P2-P1}{1+(\frac{N_{d}}{p3}) ^{p4}} \right)$ , and $\mu_{p} = p5 +  \left(\frac{P6-P5}{1+(\frac{N_{a}}{p7}) ^{p8}} \right)$
3: $\mu_{n,0} = p1 +  \left(\frac{P2-P1}{1+(\frac{N_{d}}{p3}) ^{p4}} \right)$,  $\mu_{n} = \mu_{n,0} \times \left(\frac{T}{p5}\right) ^{p6}$ , and 
   $\mu_{p,0} = p7 +  \left(\frac{P8-P7}{1+(\frac{N_{d}}{p9}) ^{p10}} \right)$,  $\mu_{p} = \mu_{p,0} \times \left(\frac{T}{p11}\right) ^{p12}$.

If the mobility is for activated dopant density then

21: $\mu_{n} = p1 +  \left(\frac{P2-P1}{1+(\frac{N_{d}^{+}}{p3}) ^{p4}} \right)$ , and $\mu_{p} = p5 +  \left(\frac{P6-P5}{1+(\frac{N_{a}^{-}}{p7}) ^{p8}} \right)$
31: $\mu_{n,0} = p1 +  \left(\frac{P2-P1}{1+(\frac{N_{d}^{+}}{p3}) ^{p4}} \right)$,  $\mu_{n} = \mu_{n,0} \times \left(\frac{T}{p5}\right) ^{p6}$ , and 
    $\mu_{p,0} = p7 +  \left(\frac{P8-P7}{1+(\frac{N_{a}^{-}}{p9}) ^{p10}} \right)$,  $\mu_{p} = \mu_{p,0} \times \left(\frac{T}{p11}\right) ^{p12}$.

The $usemubydopeT setting in GUI interface is here
After setting up the general structure, press Thermal, check the box and set the fields as needed!