2D Vpit LED View the results

● Press the result viewer button

● 2D Result SOP
1. Choose the project name
2. Choose the data type

(1)  IV And IQE (Usually Use)
(2)  2D Node-Base Data (Usually Use)
(3)  2D Element-Base Data
(4)  2D Ray Tracing
(5)  2D Triangular Mesh
(6)  2D Node Parameter Check (Usually Use)
(7)  2D Element Parameter Check
(8)  2D Nsum Data
(9)  2D Eigen Wave
(10) 2D RCWA 

3. Selecting voltage points (if necessary)
4. Choose the x-axis and y-axis data
5. Choose the figure type

(1)  x-y plot
(2)  2D triangular mesh
     (a) Plot the complete data for both the x-axis and y-axis
     (b) Plot along the y-axis at a fixed x-point
     (c) Plot along the x-axis at a fixed y-point
(3)  3D triangular mesh

6. Hold on (if necessary)
7. Plot
Notice: Remember to normalize the 2D current density by the chip width (cm) when plotting current data.

★★★ There are some result examples for this case. ★★★

● IV figure (linear)

● Band structure figure

★ Ec (along y-axis)

★ Use "hold on" to plot different x-point along the y-axis

★ Use "hold on" to plot Ec and Efn in the same figure (along y-axis)

● Radiative Rates figure (along y-axis)

● Carreir Density figure (along y-axis)

★ n density

● 2D Current Density figure

★ Jn



★ Jp

● 2D Band Structure figure

★ Ec

● 2D Radiative Rates figure

★ Radiative recombination at different voltages

● 2D Nonradiative Rates figure

● 2D Carrier Density figure

★ n



★ p

● Parameter Check

You can check whether the different parameters are set correctly.
Ex: region number, Eg, dope, effective mass, impurity, taun(nonrad), taup(nonrad)...

★ Eg



★ Dope