$gatebias

出自 DDCC TCAD TOOL Manual
於 2017年8月14日 (一) 20:57 由 Yrwu (對話 | 貢獻) 所做的修訂 (已建立頁面,內容為 "To determine the bias added to the gate contact. It should be written in one row with three numbers which represent the start of the bias voltage the end of the bia...")

(差異) ←上個修訂 | 最新修訂 (差異) | 下個修訂→ (差異)
前往: 導覽搜尋

To determine the bias added to the gate contact. It should be written in one row with three numbers which represent the start of the bias voltage the end of the bias voltage and the step size of the voltage in sequence. For example:

$gatebias 
-0.3 0.3 0.1 

This means that the bias of the gate contact will starts at 0V and increases 0.1V every step until the gate bias reached 0.4V.
i.e. -0.3 -0.2 -0.1 0 0.1 0.2 0.3