檢視 $RCWAtotallayer 的原始碼

$RCWAtotallayer required setting tag the layer number of the device. This layer number needs to be set in the beginning of input file. It is different from $totallayer. <br />
In addition, layer1, layer_{RCWAtotallayer}, layer_{RCWAtotallayer-1}, and layer_{RCWAtotallayer-2} should be homogeneous.

<big><big>'''Example'''</big></big>
 $RCWAtotallayer <br>
 8

<big>'''The $RCWAtotallayer setting for 1D-DDCC in GUI interface '''</big> <br>

3.Layer number in here.<br>
[[檔案:1d_$RCWAtotallayer_fig1.jpg|1300px]]<br>


<big>'''The $RCWAtotallayer setting for 2D-DDCC in GUI interface '''</big> <br>
Note. The total layer number shown in 2D-DDCC is the '''actual number +2'''. Here, I set a different material for the topmost layer '''(5)''' compared to the bottom layers '''(1~4)''' to improve clarity. For unknown reasons, the topmost layer is divided into three sublayers with a thickness ratio of 2:1:1. Thankfully, the parameters in these sublayers are identical, so they can be treated as a single layer.
<br>
[[檔案:2D_RCWAtotallayer_fig1.jpg|1200px]]