"$ifapplytauofT" 修訂間的差異
出自 DDCC TCAD TOOL Manual
(已建立頁面，內容為 "$ifapplytauofT is to enable the temperature-dependent nonradiative lifetime module with the predefined function. The function is designed for each region. So if tot...") |
|||
| (未顯示同一使用者於中間所作的 2 次修訂) | |||
| 行 1： | 行 1： | ||
$ifapplytauofT is to enable the temperature-dependent nonradiative lifetime module with the predefined function. The function is designed for each region. |
$ifapplytauofT is to enable the temperature-dependent nonradiative lifetime module with the predefined function. The function is designed for each region. |
||
| − | So if total n regions |
+ | So if total n regions are used, then you will need to set up n regions. The format is |
| − | $usetaunrbyfunc |
||
| + | $ifapplytauofT |
||
p1 p2 p3 p4 p5.....p6 |
p1 p2 p3 p4 p5.....p6 |
||
p1 p2 p3 p4 p5.....p6 |
p1 p2 p3 p4 p5.....p6 |
||
| 行 9： | 行 9： | ||
... |
... |
||
... |
... |
||
| − | + | p1 p2 p3 p4 .....p6 |
|
<math> \tau_{n} = p1 \times (\frac{T}{p3}) ^{p2} </math> , and <math> \tau_{p} = p4 \times (\frac{T}{p6}) ^{p5} </math> |
<math> \tau_{n} = p1 \times (\frac{T}{p3}) ^{p2} </math> , and <math> \tau_{p} = p4 \times (\frac{T}{p6}) ^{p5} </math> |
||
| + | |||
| + | |||
| + | The related commands are: [[$ifapplytauofT]], [[$ifapplymuofT]], [[$ifapplyEgofT]], [[$ifTversusJ]] |
||
於 2021年6月9日 (三) 09:41 的最新修訂
$ifapplytauofT is to enable the temperature-dependent nonradiative lifetime module with the predefined function. The function is designed for each region. So if total n regions are used, then you will need to set up n regions. The format is
$ifapplytauofT p1 p2 p3 p4 p5.....p6 p1 p2 p3 p4 p5.....p6 p1 p2 p3 p4 p5.....p6 ... ... ... p1 p2 p3 p4 .....p6
, and
The related commands are: $ifapplytauofT, $ifapplymuofT, $ifapplyEgofT, $ifTversusJ
