"$eigensetting" 修訂間的差異
出自 DDCC TCAD TOOL Manual
(已建立頁面，內容為 "$eigensetting is the command to tell program the the maximum eigen values obtained for electron and hole states. Usage:<br> $eigensetting <br> @max_En @max_Ep...") |
|||
| 行 17： | 行 17： | ||
In this case, only 30 electron eigen values and 20 hole eigen values are obtained. <br> |
In this case, only 30 electron eigen values and 20 hole eigen values are obtained. <br> |
||
| + | |||
| + | <br>'''<big><big>The $eigensetting setting in GUI interface is here</big></big>''' <br> |
||
| + | Press '''Schrödinger Eigen Solver''', check the box, and set the electron eigen values to 30 and the hole eigen values to 20!<br> |
||
| + | [[檔案:2D_eigensetting_fig1.jpg|1200px]]<br> |
||
| + | |||
The related commands are: <br> |
The related commands are: <br> |
||
於 2024年9月22日 (日) 22:28 的修訂
$eigensetting is the command to tell program the the maximum eigen values obtained for electron and hole states.
Usage:
$eigensetting
@max_En @max_Ep
The program will only obtain the max_En of electron eigen values and @max_Ep hole eigen values.
For example:
$solveeigenvalue $solveeigenbias 2.00 4.00 3.00 7.00 $eigensetting 30 20
In this case, only 30 electron eigen values and 20 hole eigen values are obtained.
The $eigensetting setting in GUI interface is here
Press Schrödinger Eigen Solver, check the box, and set the electron eigen values to 30 and the hole eigen values to 20!
The related commands are:
$solveeigenvalue, $solveeigenbias, $usefeast, $eigencalEl
