"$UseAuger" 修訂間的差異
出自 DDCC TCAD TOOL Manual
Jameshuang (對話 | 貢獻) |
|||
| (未顯示由 3 位使用者於中間所作的 5 次修訂) | |||
| 行 7： | 行 7： | ||
3rd layer layer's auger coefficient |
3rd layer layer's auger coefficient |
||
. . . |
. . . |
||
| − | nth layer layer's auger coefficien <math>(cm^{6}s^{-1})</math> |
+ | nth layer layer's auger coefficien <math>(cm^{6}s^{-1})</math> the nth layer is decided by [[$totallayer]] |
<big><big>'''Example'''</big></big> |
<big><big>'''Example'''</big></big> |
||
| 行 14： | 行 14： | ||
8.0e-31 |
8.0e-31 |
||
8.0e-31 |
8.0e-31 |
||
| + | |||
| + | <big>'''The $UseAuger setting for 1D-DDCC in GUI interface '''</big> <br> |
||
| + | |||
| + | '''$UseAuger''' will only appear in the input file if '''Auger''' is pressed. <br> |
||
| + | |||
| + | [[檔案:1d_$UseAuger_fig1.jpg|1300px]] |
||
| + | |||
| + | |||
| + | <big>'''The $UseAuger setting for 2D-DDCC in GUI interface '''</big> <br> |
||
| + | Press '''Material Parameter''' , check the box and fill in the fields for the '''Auger (C)''' as needed!<br> |
||
| + | [[檔案:2D_UseAuger_fig1.jpg|1300px]]<br> |
||
於 2024年9月22日 (日) 23:39 的最新修訂
This function is to consider the auger recombination in the device. Fill in the auger recombination coefficient of each layer.
Format
$Useauger 1st layer layer's auger coefficient 2nd layer layer's auger coefficient 3rd layer layer's auger coefficient . . . nth layer layer's auger coefficienthe nth layer is decided by $totallayer
Example
$Useauger 8.0e-31 8.0e-31 8.0e-31
The $UseAuger setting for 1D-DDCC in GUI interface
$UseAuger will only appear in the input file if Auger is pressed.
The $UseAuger setting for 2D-DDCC in GUI interface
Press Material Parameter , check the box and fill in the fields for the Auger (C) as needed!
