"$emptyperiodshape" 修訂間的差異
出自 DDCC TCAD TOOL Manual
Jameshuang (對話 | 貢獻) |
|||
| (未顯示由 2 位使用者於中間所作的 3 次修訂) | |||
| 行 1： | 行 1： | ||
| − | $emptyperiodshape is a function that you can set difference empty shape for period. It is the same as [[$ |
+ | $emptyperiodshape is a function that you can set difference empty shape for period. It is the same as [[$emptyperiodtriangle]] |
'''<big><big>Format</big></big>''' |
'''<big><big>Format</big></big>''' |
||
| 行 33： | 行 33： | ||
Type.5 and 6 can be determined by this expression: |
Type.5 and 6 can be determined by this expression: |
||
| − | <math>f_6<y< |
+ | <math>f_6<y<f_1sin(f_2x)+f_3;</math><br /> |
<math>f_4<x<f_5</math> |
<math>f_4<x<f_5</math> |
||
| 行 39： | 行 39： | ||
Type.7 and 8 can be determined by this expression: |
Type.7 and 8 can be determined by this expression: |
||
| − | <math>f_6<x< |
+ | <math>f_6<x<f_1sin(f_2y)+f_3;</math><br /> |
<math>f_4<y<f_5</math> |
<math>f_4<y<f_5</math> |
||
| − | [[檔案:pic2.png|700px |
+ | [[檔案:pic2.png|700px]] |
| − | [[$emptyperiodshape]], |
||
| + | |||
| + | <br>'''<big><big>The $emptyperiodshape setting in GUI interface is here</big></big>''' <br> |
||
| + | 1. After setting up one contact, we can set the period for empty shapes as needed!<br> |
||
| + | [[檔案:2D_emptyperiodshape_fig1.jpg|1200px]]<br><br> |
||
| + | |||
| + | [[$emptyperiodtriangle]], |
||
於 2024年10月27日 (日) 02:20 的最新修訂
$emptyperiodshape is a function that you can set difference empty shape for period. It is the same as $emptyperiodtriangle
Format
$emptyperiodshape n type1 f1 f2 f3 f4 f5 f6 int_period_num f_period_spacing
Parameter Explanation
- n : number of empty section.
- type : type1=triangle, type2=circle, type3=ellipse, type4=rectangular, type5=Sinkx function up, type6=Sinkx function down, type7=Sinkx function up, type8=Sinkx function down.
- f1-f6 : you can refer to the information where at bottom of this page.
- int_period_num :
- f_period_spacing :
Example
Type.1~4 are triangle, circle, ellipse and rectangle.
If the parameters are not show in the figure, you should set those parameters as 0.
Type5~8 are sine shape period structure.
Type.5 and 6 can be determined by this expression:
Type.7 and 8 can be determined by this expression:
The $emptyperiodshape setting in GUI interface is here
1. After setting up one contact, we can set the period for empty shapes as needed!
