「2D LED View the results」：修訂間差異
跳至導覽
跳至搜尋
無編輯摘要 |
無編輯摘要 |
||
| 第6行： | 第6行： | ||
1. Choose the project name<br> | 1. Choose the project name<br> | ||
2. Choose the data type<br> | 2. Choose the data type<br> | ||
IV And IQE (Usually Use) | (01) IV And IQE (Usually Use) | ||
2D Node-Base Data (Usually Use) | (02) 2D Node-Base Data (Usually Use) | ||
2D Element-Base Data | (03) 2D Element-Base Data | ||
2D Ray Tracing | (04) 2D Ray Tracing | ||
2D Triangular Mesh | (05) 2D Triangular Mesh | ||
2D Node Parameter Check (Usually Use) | (06) 2D Node Parameter Check (Usually Use) | ||
2D Element Parameter Check | (07) 2D Element Parameter Check | ||
2D Nsum Data | (08) 2D Nsum Data | ||
2D Eigen Wave | (09) 2D Eigen Wave | ||
2D RCWA Choose the x-axis and y-axis data<br> | (10) 2D RCWA | ||
3. Choose the x-axis and y-axis data<br> | |||
x-y plot | 4. Choose the figure type <br> | ||
2D triangular mesh | (01)x-y plot | ||
Plot the complete data for both the x-axis and y-axis | (02)2D triangular mesh | ||
Plot along the y-axis at a fixed x-point | (a)Plot the complete data for both the x-axis and y-axis | ||
Plot along the x-axis at a fixed y-point | (b)Plot along the y-axis at a fixed x-point | ||
3D triangular mesh | (c)Plot along the x-axis at a fixed y-point | ||
(03)3D triangular mesh | |||
5. Hold on (if necessary)<br> | 5. Hold on (if necessary)<br> | ||
6. Plot<br> | 6. Plot<br> | ||
Notice: Remember to normalize the 2D current density by the chip width (cm) when plotting current data.<br> | Notice: Remember to normalize the 2D current density by the chip width (cm) when plotting current data.<br> | ||
於 2025年1月1日 (三) 10:28 的修訂
● Press the result viewer button
● 2D Result SOP
1. Choose the project name
2. Choose the data type
(01) IV And IQE (Usually Use) (02) 2D Node-Base Data (Usually Use) (03) 2D Element-Base Data (04) 2D Ray Tracing (05) 2D Triangular Mesh (06) 2D Node Parameter Check (Usually Use) (07) 2D Element Parameter Check (08) 2D Nsum Data (09) 2D Eigen Wave (10) 2D RCWA
3. Choose the x-axis and y-axis data
4. Choose the figure type
(01)x-y plot (02)2D triangular mesh (a)Plot the complete data for both the x-axis and y-axis (b)Plot along the y-axis at a fixed x-point (c)Plot along the x-axis at a fixed y-point (03)3D triangular mesh
5. Hold on (if necessary)
6. Plot
Notice: Remember to normalize the 2D current density by the chip width (cm) when plotting current data.