「$RCWAtotallayer」：修訂間差異
已建立頁面，內容為 "$RCWAtotallayer required setting tag the layer number of the device. This layer number needs to be set in the beginning of input file. It is different from $totallay..." |
無編輯摘要 |
||
| （未顯示由 2 位使用者於中間所作的 3 次修訂） | |||
| 第1行： | 第1行： | ||
$RCWAtotallayer required setting tag the layer number of the device. This layer number needs to be set in the beginning of input file. It is different from $totallayer. <br /> | $RCWAtotallayer required setting tag the layer number of the device. This layer number needs to be set in the beginning of input file. It is different from $totallayer. <br /> | ||
In addition, layer1, layer_{RCWAtotallayer}, layer_{RCWAtotallayer-1}, and layer_{RCWAtotallayer-2} should be homogeneous. | |||
<big><big>'''Example'''</big></big> | <big><big>'''Example'''</big></big> | ||
$RCWAtotallayer <br> | $RCWAtotallayer <br> | ||
5 | 8 | ||
<big>'''The $RCWAtotallayer setting for 1D-DDCC in GUI interface '''</big> <br> | |||
3.Layer number in here.<br> | |||
[[檔案:1d_$RCWAtotallayer_fig1.jpg|1300px]]<br> | |||
<big>'''The $RCWAtotallayer setting for 2D-DDCC in GUI interface '''</big> <br> | |||
Note. The total layer number shown in 2D-DDCC is the '''actual number +2'''. Here, I set a different material for the topmost layer '''(5)''' compared to the bottom layers '''(1~4)''' to improve clarity. For unknown reasons, the topmost layer is divided into three sublayers with a thickness ratio of 2:1:1. Thankfully, the parameters in these sublayers are identical, so they can be treated as a single layer. | |||
<br> | |||
[[檔案:2D_RCWAtotallayer_fig1.jpg|1200px]] | |||
於 2025年1月20日 (一) 08:54 的最新修訂
$RCWAtotallayer required setting tag the layer number of the device. This layer number needs to be set in the beginning of input file. It is different from $totallayer.
In addition, layer1, layer_{RCWAtotallayer}, layer_{RCWAtotallayer-1}, and layer_{RCWAtotallayer-2} should be homogeneous.
Example
$RCWAtotallayer
8
The $RCWAtotallayer setting for 1D-DDCC in GUI interface
3.Layer number in here.
The $RCWAtotallayer setting for 2D-DDCC in GUI interface
Note. The total layer number shown in 2D-DDCC is the actual number +2. Here, I set a different material for the topmost layer (5) compared to the bottom layers (1~4) to improve clarity. For unknown reasons, the topmost layer is divided into three sublayers with a thickness ratio of 2:1:1. Thankfully, the parameters in these sublayers are identical, so they can be treated as a single layer.
