"$ifapplymuofT" 修訂間的差異
出自 DDCC TCAD TOOL Manual
| (未顯示由 1 位使用者於中間所作的 2 次修訂) | |||
| 行 1： | 行 1： | ||
| − | $ifapplymuofT is to activate temperature |
+ | $ifapplymuofT is to activate temperature-dependent mobility setting. |
| − | + | ||
| − | $usemubydopeT is to enable the temperature and carrier density dependent mobility module with the predefined function. The function is designed for each region. |
||
| − | So if total n regions is used, then you will need to setup n regions. The format is |
||
$ifapplymuofT |
$ifapplymuofT |
||
| 行 13： | 行 13： | ||
Type |
Type |
||
| − | + | <math> \mu_{n} = p1 \times \left(\frac{T}{p3}\right) ^{p2} </math> , and <math> \mu_{p} = p4 \times \left(\frac{T}{p6}\right) ^{p5} </math> |
|
| + | p1 is the <math> \mu_{n} (300K) </math> |
||
| + | p4 is the <math> \mu_{p} (300K) </math> |
||
| + | |||
| + | <big>'''The $ifapplymuofT setting for 1D-DDCC in GUI interface '''</big> <br> |
||
| + | |||
| + | The parameters are modified in '''Step 4'''.<br> |
||
| + | [[檔案:1d_$ifapplymuofT_fig1.jpg|1300px]]<br> |
||
| + | |||
| + | The related commands are: [[$ifapplytauofT]], [[$ifapplymuofT]], [[$ifapplyEgofT]], [[$ifTversusJ]] |
||
於 2024年11月22日 (五) 18:18 的最新修訂
$ifapplymuofT is to activate temperature-dependent mobility setting.
$ifapplymuofT p1 p2 p3 p4 p5.....p6 p1 p2 p3 p4 p5.....p6 p1 p2 p3 p4 p5.....p6 ... ... ... p1 p2 p3 p4 .....p6
Type
, and
p1 is the
p4 is the
The $ifapplymuofT setting for 1D-DDCC in GUI interface
The parameters are modified in Step 4.
The related commands are: $ifapplytauofT, $ifapplymuofT, $ifapplyEgofT, $ifTversusJ
