"$emptyperiodshape" 修訂間的差異
出自 DDCC TCAD TOOL Manual
Jameshuang (對話 | 貢獻) |
Jameshuang (對話 | 貢獻) |
||
| 行 1： | 行 1： | ||
| − | $emptyperiodshape is a function that you can set difference empty shape for period. It is the same as [[$ |
+ | $emptyperiodshape is a function that you can set difference empty shape for period. It is the same as [[$emptyperiodtriangle]] |
'''<big><big>Format</big></big>''' |
'''<big><big>Format</big></big>''' |
||
| 行 45： | 行 45： | ||
[[檔案:pic2.png|700px|left]] |
[[檔案:pic2.png|700px|left]] |
||
| − | [[$emptyperiodshape]], |
||
| + | [[$emptyperiodtriangle]], |
||
於 2017年8月27日 (日) 14:24 的修訂
$emptyperiodshape is a function that you can set difference empty shape for period. It is the same as $emptyperiodtriangle
Format
$emptyperiodshape n type1 f1 f2 f3 f4 f5 f6 int_period_num f_period_spacing
Parameter Explanation
- n : number of empty section.
- type : type1=triangle, type2=circle, type3=ellipse, type4=rectangular, type5=Sinkx function up, type6=Sinkx function down, type7=Sinkx function up, type8=Sinkx function down.
- f1-f6 : you can refer to the information where at bottom of this page.
- int_period_num :
- f_period_spacing :
Example
Type.1~4 are triangle, circle, ellipse and rectangle.
If the parameters are not show in the figure, you should set those parameters as 0.
Type5~8 are sine shape period structure.
Type.5 and 6 can be determined by this expression:
Type.7 and 8 can be determined by this expression:
