"$pattern tri period" 修訂間的差異
出自 DDCC TCAD TOOL Manual
| 行 11： | 行 11： | ||
* pattern_tri_num : number of empty section. |
* pattern_tri_num : number of empty section. |
||
* type : type1=triangle, type2=circle, type3=ellipse, type4=rectangular, type5=Sinkx function up, type6=Sinkx function down, type7=Sinkx function up, type8=Sinkx function down. |
* type : type1=triangle, type2=circle, type3=ellipse, type4=rectangular, type5=Sinkx function up, type6=Sinkx function down, type7=Sinkx function up, type8=Sinkx function down. |
||
| − | * f1-f6 : you can refer to the information where at bottom of this page. |
+ | * f1-f6 : you can refer to the information where at bottom of this page. (unit is cm!) |
* int_period_num : |
* int_period_num : |
||
| − | * f_period_spacing : |
+ | * f_period_spacing : (unit is cm!) |
@type: |
@type: |
||
於 2017年12月26日 (二) 11:51 的修訂
The pattern tri period is the same definition in pattern type as the
$pattern_tri_period pattern_tri_num pattern_type int_period_num f_period_spacing
if_empty
Parameter Explanation
- pattern_tri_num : number of empty section.
- type : type1=triangle, type2=circle, type3=ellipse, type4=rectangular, type5=Sinkx function up, type6=Sinkx function down, type7=Sinkx function up, type8=Sinkx function down.
- f1-f6 : you can refer to the information where at bottom of this page. (unit is cm!)
- int_period_num :
- f_period_spacing : (unit is cm!)
@type: 1 : triangular , period along x if the periodnumber >1 11 : triangular , period along y if the periodnumber >1 2 : circular shape, period along x if the periodnumber >1 21 : circular shape, period along y if the periodnumber >1 3 : elliptic shape, period along x if the periodnumber >1 31 : elliptic shape, period along y if the periodnumber >1 4 : rectangular shape, period along x if the periodnumber >1 41 : rectangular shape, period along y if the periodnumber >1 5: sin kx function up, the shape is defined by x_left, x_right, y>sinkx and y<y2 6: sin kx function down, the shape is defined by x_left, x_right, y<sinkx and y>y2 7: sin ky function up (be careful to use it), the shape is defined by y_top, y_bottom, x<sinky and x>x2 8: sin ky function right (be careful to use it), the shape is defined by y_top, y_bottom, x<sinky and x>x2
Example
Type.1~4 are triangle, circle, ellipse and rectangle.
If the parameters are not show in the figure, you should set those parameters as 0.
Type5~8 are sine shape period structure.
Type.5 and 6 can be determined by this expression:
Type.7 and 8 can be determined by this expression:
